Model P-50
Owners Manual
Table of Contents
Assembly Instructions…………………………………..……..2-7
Use and Operation of Your PROSPOTfitness® Product…...…8-10
Periodic Maintenance of your PROSPOTfitness® Product….…11
Parts List…………………………………………………….…12
Trouble-Shooting ………………………………………….…13-14
Warranty & Contact Information……………………….…….15
Serial Number: 18604R00175P50
-- 1 --
STEP # 1: P-50 MAIN FRAME ASSEMBLY
1. Place the two main pre-assembled side frames left & right respectfully opposite each other
in the center of the assembly area as shown in the Illustration. Place the Back Base Rail
(3) between the two Side Base Rails (1 & 2) so that the side pre-drilled holes of the Base
Rails (1 & 2) align with the end holes of the Back Base Rail (3).
2. Attach the two main pre-assembled side frames to the Back Base Rail (3) using two Cross
Brace Backing Plates (4), four bolts (66), eight washers (77) and four nuts (81) as shown.
HAND TIGHTEN the bolts at this time.
3. Now attach the two main pre-assembled side frames to the Top Rail (16) using four bolts
(66), eight washers (77) and four nuts (81) as shown. HAND TIGHTEN the bolts at this
time.
4. Attach Electronic Box Locating Board (11) to Back Base Rail (3) using two bolts (65), two
washers (77) and two nuts (81).
5. Tighten all bolts and nuts used for assembly in previous steps.
6. Carefully thread both Base Wire Harness's thru the center hole in the Back Base Rail (3).
7. Plug in both Base Wire Harness's into sides of Electronic Box (13).
8. Install Protective Cover (12) over Electronic Box with two screws (70).
9. Snap both Base Wire Harness's into Channels (90) and push any excess into hole in Side
Base Rails (1& 2).
10.Untie the coiled left & right Weight Bar Cables, so that they hang straight down with out
any twists or tangles. Be sure that the cables are straight and uncrossed and cables
and pulleys move smoothly.
STEP #2: SENSOR WEIGHT BAR INSTALLATION
1. Standing in front of the ProSpot Fitness® P-50. Insert one end and then the other end of
the Sensor Weight Bar (31) into the Cable Knuckles (46-48). Slide the Cable Knuckles
onto the Bar until they rest snugly against the preinstalled sensor retaining collars (45 &
48) at each end of the Sensor Weight Bar (31). (There is a rotation-limiting pin that
protrudes from the bottom of the Sensor Weight Bar (31) that must fit through a slot in the
knuckles (46-48) as it is slid into position).
2. Place one Plastic Locking Sleeve (36) onto each end of the Sensor Weight Bar (25) and
slide them inwards until they butt up against and secure the Weight Bar Cable Knuckle in
place. Tighten Plastic Locking Sleeve bolts securely with 4mm Allen wrench (95) provided.
3. Place one of the Olympic Adapters (32) onto the Sensor Weight Bar (31) and slide them
onto the Bar, then insert the Weight Bar Shoulder Bolt (34) onto each end of the Sensor
Weight Bar (31). Secure with provided 9/16" Allen wrench (97).
-- 3 --
-- 4 --
|